TOYOTA WISH (AE20) 2.0L 16V 116kW/157HP DENSO

ECU DENSO 275922-3410 · 158 CV (116 kW) · 2000 cc · Benzina aspirato

ECU DatabaseTOYOTA › TOYOTA WISH (AE20) 2.0L 16V 116kW/157HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 2 firmware versions

Vehicle data

BrandTOYOTA
ModelWISH (AE20)
Engine2.0L 16V 116kW/157HP DENSO
Stock power158 CV / 116 kW
Displacement2000 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275922-3410
Memory / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Available tuning operations / options:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(IAT) 2
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Lambda correction f(ECT) 3
  • Lambda correction f(ECT) 4
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor

Firmware identifiers (2)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-0M022- 1.67.00330M02200 DENSO 275922-3410
89663-0M020- 1.67.02230M02000 DENSO 275922-3410

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata