TOYOTA YARIS (XP10) 1.5L 16V VVT-i 78kW/99HP DENSO

ECU DENSO 275036-1150 · 106 CV (78 kW) · 1500 cc · Benzina aspirato

ECU DatabaseTOYOTA › TOYOTA YARIS (XP10) 1.5L 16V VVT-i 78kW/99HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 6 firmware versions

Vehicle data

BrandTOYOTA
ModelYARIS (XP10)
Engine1.5L 16V VVT-i 78kW/99HP DENSO
Stock power106 CV / 78 kW
Displacement1500 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275036-1150
Memory / EPROMMICRO NEC 76F0039GD - 512 Kbit - 80000

Available tuning operations / options:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet

Firmware identifiers (6)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-52840-A 1.67.03535284000 DENSO 275036-1150
89663-0D202- 1.00.00630D20200 DENSO 275036-1152
89663-0D200- 1.00.00730D20000 DENSO 275036-1152
89663-0D570-A 1.67.00430D57000 DENSO 275036-1152
89663-0D201- 1.00.00530D20100 DENSO 275036-1152
89663-0D191- 1.00.00530D19100 DENSO 275036-1152

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata