TOYOTA URBAN CRUISER 1.3L 16V 74kW/99HP DENSO

ECU DENSO 275922-5280/5380 · 101 CV (74 kW) · 1300 cc · Benzina aspirato

ECU DatabaseTOYOTA › TOYOTA URBAN CRUISER 1.3L 16V 74kW/99HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 2 firmware versions

Vehicle data

BrandTOYOTA
ModelURBAN CRUISER
Engine1.3L 16V 74kW/99HP DENSO
Stock power101 CV / 74 kW
Displacement1300 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275922-5280/5380
Memory / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Available tuning operations / options:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • L
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware identifiers (2)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-52K81- 1.67.014352K8100 DENSO 275922-5280/5380
89663-52K82- 1.67.005352K8200 DENSO 275922-5280/5380

Vehicle technical notes

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU notes

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata