TOYOTA RAV4 (XA40) 2.0L 16V D-4D 91kW/122HP DENSO

ECU DENSO 275922-500 · 124 CV (91 kW) · 2000 cc · Diesel sovralimentato

ECU DatabaseTOYOTA › TOYOTA RAV4 (XA40) 2.0L 16V D-4D 91kW/122HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 2 firmware versions

Vehicle data

BrandTOYOTA
ModelRAV4 (XA40)
Engine2.0L 16V D-4D 91kW/122HP DENSO
Stock power124 CV / 91 kW
Displacement2000 cc
FuelDiesel sovralimentato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275922-500
Memory / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Available tuning operations / options:

  • Boost pressure limiter for diagnostics
  • Boost pressure limiter
  • Boost pressure
  • Boost pressure 2
  • Boost pressure 3
  • EGR valve control
  • EGR valve control 2
  • Variable boost pressure 1
  • Injection correction 2
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Max injection limit
  • Max injection limit for APS/BPS sensor
  • Max injection limit - limp mode
  • Injection correction
  • Injection correction for IAT sensor
  • J
  • Injection 2
  • Speed limiter
  • Maximum possible engine charge
  • Main injection
  • Specific injection pressure limiter
  • Specific injection pressure
  • Specific injection pressure 3
  • Q
  • Air mass flow
  • Driver torque request
  • Variable geometry duty cycle limit
  • Variable geometry duty cycle limit 2

Firmware identifiers (2)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-42N40- 1.67.015342N4000 DENSO 275922-500
89663-42F90- 1.51.029342F9000 DENSO 275922-500

Vehicle technical notes

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU notes

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Add-on modules available

→ See all add-on modules on the shop