TOYOTA RAV4 (XA30) 2.5L 16V 133kW/178HP DENSO

ECU DENSO 275922-5280/5380 · 181 CV (133 kW) · 2500 cc · Benzina aspirato

ECU DatabaseTOYOTA › TOYOTA RAV4 (XA30) 2.5L 16V 133kW/178HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 3 firmware versions

Vehicle data

BrandTOYOTA
ModelRAV4 (XA30)
Engine2.5L 16V 133kW/178HP DENSO
Stock power181 CV / 133 kW
Displacement2500 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275922-5280/5380
Memory / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Available tuning operations / options:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(IAT) 2
  • Lambda correction f(ECT)
  • Gearbox maximum torque allowed
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 3
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware identifiers (3)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-42F13- 1.67.011342F1300 DENSO 275922-5280/5380
89663-42881- 1.67.00334288100 DENSO 275922-5280/5380
89663-42G90- 1.67.004342G9000 DENSO 275922-5280/5380

ECU notes

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata