TOYOTA RAV4 (XA30) 2.2L 16V D-4D 110kW/148HP DENSO

ECU DENSO 275922-022 · 150 CV (11 kW) · 2200 cc · Diesel sovralimentato

ECU DatabaseTOYOTA › TOYOTA RAV4 (XA30) 2.2L 16V D-4D 110kW/148HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 4 firmware versions

Vehicle data

BrandTOYOTA
ModelRAV4 (XA30)
Engine2.2L 16V D-4D 110kW/148HP DENSO
Stock power150 CV / 11 kW
Displacement2200 cc
FuelDiesel sovralimentato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275922-022
Memory / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Available tuning operations / options:

  • Boost pressure limiter for diagnostics
  • Boost pressure limiter
  • Boost pressure
  • Boost pressure 2
  • Boost pressure 3
  • EGR valve control
  • EGR valve control 2
  • Variable boost pressure 1
  • Injection correction 2
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Max injection limit
  • Max injection limit for APS/BPS sensor
  • Max injection limit - limp mode
  • Injection correction
  • Injection correction for IAT sensor
  • J
  • Injection 2
  • Speed limiter
  • Maximum possible engine charge
  • Main injection
  • Specific injection pressure
  • Q
  • Air mass flow
  • Variable geometry duty cycle limit
  • Variable geometry duty cycle limit 3

Firmware identifiers (4)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-42B16- 1.67.005342B1600 DENSO 275922-022
89663-42A90- 1.67.006342A9000 DENSO 275922-022
89663-42B11- 1.67.012342B1100 DENSO 275922-022
89663-42B15- 1.67.008342B1500 DENSO 275922-022

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata