TOYOTA RAV4 (XA30) 2.0L 16V 112kW/150HP DENSO

ECU DENSO 275036-1152 · 152 CV (112 kW) · 2000 cc · Benzina aspirato

ECU DatabaseTOYOTA › TOYOTA RAV4 (XA30) 2.0L 16V 112kW/150HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 5 firmware versions

Vehicle data

BrandTOYOTA
ModelRAV4 (XA30)
Engine2.0L 16V 112kW/150HP DENSO
Stock power152 CV / 112 kW
Displacement2000 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275036-1152
Memory / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Available tuning operations / options:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet

Firmware identifiers (5)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-0R021- 1.67.01530R02100 DENSO 275036-1152
89663-42601- 1.67.00534260100 DENSO 275036-1152
89663-0R020- 1.67.00530R02000 DENSO 275036-1152
89663-42602- 1.67.00734260200 DENSO 275036-1152
275100-372189663-42610-A 1.67.01934261000 DENSO 275036-1152

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata