TOYOTA PRIUS (XW20) 1.5L 16V L4 57kW/76HP DENSO

ECU DENSO 275036-5650 · 77 CV (57 kW) · 1500 cc · Benzina aspirato

ECU DatabaseTOYOTA › TOYOTA PRIUS (XW20) 1.5L 16V L4 57kW/76HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 5 firmware versions

Vehicle data

BrandTOYOTA
ModelPRIUS (XW20)
Engine1.5L 16V L4 57kW/76HP DENSO
Stock power77 CV / 57 kW
Displacement1500 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275036-5650
Memory / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Available tuning operations / options:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • % relative air filling limit depending on IAT
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 2
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware identifiers (5)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-47430- 1.67.00934743000 DENSO 275036-5650
89663-47070-A 1.67.01434707000 DENSO 275036-7780
89663-47070- 1.67.00434707000 DENSO 275036-7780
89663-47121- 1.67.00634712100 DENSO 275036-7780
89663-47080-A 1.67.02634708000 DENSO 275036-7780

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

Microprocessor NEC 76F0040GD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata