TOYOTA LAND CRUISER (J200) 4.5L V8 32V D-4D 210kW/286HP DENSO

ECU DENSO 275922-001 · 286 CV (21 kW) · 4500 cc · Diesel sovralimentato

ECU DatabaseTOYOTA › TOYOTA LAND CRUISER (J200) 4.5L V8 32V D-4D 210kW/286HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 5 firmware versions

Vehicle data

BrandTOYOTA
ModelLAND CRUISER (J200)
Engine4.5L V8 32V D-4D 210kW/286HP DENSO
Stock power286 CV / 21 kW
Displacement4500 cc
FuelDiesel sovralimentato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275922-001
Memory / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Available tuning operations / options:

  • Boost pressure limiter for diagnostics
  • Boost pressure limiter
  • Boost pressure
  • Boost pressure 2
  • Boost pressure 3
  • EGR valve control
  • Variable boost pressure 1
  • Injection correction 2
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Max injection limit
  • Max injection limit for APS/BPS sensor
  • Max injection limit - limp mode
  • Injection correction
  • Injection correction for IAT sensor
  • J
  • Speed limiter
  • Maximum possible engine charge
  • Specific injection pressure limiter
  • Specific injection pressure
  • Air mass flow
  • Variable geometry duty cycle limit
  • Variable geometry duty cycle limit 3

Firmware identifiers (5)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-60B01- 1.51.005360B0100 DENSO 275922-001
89663-60V51- 1.67.002360V5100 DENSO 275922-001
89663-60A63- 1.51.002360A6300 DENSO 275922-001
89663-60A61- 1.51.009360A6100 DENSO 275922-001
89663-60B03- 1.51.003360B0300 DENSO 275922-001

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Add-on modules available

→ See all add-on modules on the shop