TOYOTA HIACE (H200) 3.0L 16V D-4D 80kW/108HP DENSO

ECU DENSO 175822-887 · 109 CV (8 kW) · 3000 cc · Diesel sovralimentato

ECU DatabaseTOYOTA › TOYOTA HIACE (H200) 3.0L 16V D-4D 80kW/108HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 2 firmware versions

Vehicle data

BrandTOYOTA
ModelHIACE (H200)
Engine3.0L 16V D-4D 80kW/108HP DENSO
Stock power109 CV / 8 kW
Displacement3000 cc
FuelDiesel sovralimentato
Vehicle typeLCV

ECU

ManufacturerDENSO
Model175822-887
Memory / EPROMMICRO NEC 76F0040GD - 512 Kbit - 80000

Available tuning operations / options:

  • Boost pressure limiter for diagnostics
  • Boost pressure limiter
  • Boost pressure
  • Boost pressure 2
  • EGR valve control
  • Variable boost pressure 1
  • Variable boost pressure 2
  • Injection correction 2
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Max injection limit
  • Max injection limit 2
  • Max injection limit for APS/BPS sensor
  • Max injection limit - limp mode
  • Injection correction
  • Injection correction for IAT sensor
  • J
  • Torque limiter
  • Maximum possible engine charge
  • Maximum relative engine air charge
  • Specific injection pressure limiter
  • Specific injection pressure
  • Air mass flow
  • Driver torque request
  • Variable geometry duty cycle limit

Firmware identifiers (2)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-26433- 1.67.00332643300 DENSO 175822-887
89663-26432- 1.67.00832643200 DENSO 175822-887

Vehicle technical notes

ECU located behind the glove compartment. Difficulty: medium.
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

Microprocessor NEC 76F0040GD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata