TOYOTA COROLLA (E140/E150) 2.0L 16V D-4D 93kW/125HP DENSO

ECU DENSO 176522-762 · 126 CV (93 kW) · 2000 cc · Diesel sovralimentato

ECU DatabaseTOYOTA › TOYOTA COROLLA (E140/E150) 2.0L 16V D-4D 93kW/125HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 4 firmware versions

Vehicle data

BrandTOYOTA
ModelCOROLLA (E140/E150)
Engine2.0L 16V D-4D 93kW/125HP DENSO
Stock power126 CV / 93 kW
Displacement2000 cc
FuelDiesel sovralimentato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model176522-762
Memory / EPROMMICRO NEC 76F0039AGD - 512Kbit - 80000

Available tuning operations / options:

  • Boost pressure limiter for diagnostics
  • Boost pressure limiter
  • Boost pressure
  • Boost pressure 2
  • EGR valve control
  • EGR valve control 2
  • Variable boost pressure 1
  • Variable boost pressure 2
  • Injection correction 2
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Max injection limit
  • Max injection limit for APS/BPS sensor
  • Max injection limit - limp mode
  • Injection correction
  • Injection correction for IAT sensor
  • Maximum possible engine charge
  • Main injection
  • Specific injection pressure limiter
  • Specific injection pressure
  • Air mass flow
  • Variable geometry duty cycle limit
  • Variable geometry duty cycle limit 3

Firmware identifiers (4)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-02452- 1.67.00930245200 DENSO 176522-762
89663-02575- 1.67.00330257500 DENSO 176522-762
89663-02572- 1.67.00830257200 DENSO 176522-762
89663-02E53- 1.67.008302E5300 DENSO 275922-022

Vehicle technical notes

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU notes

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Add-on modules available

→ See all add-on modules on the shop