Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.
✓ Tuning via file (flash)
✓ Add-on module available 5 firmware versions
Vehicle data
| Brand | TOYOTA |
| Model | CAMRY (XV40) |
| Engine | 3.5L V6 24V 206kW/276HP DENSO |
| Stock power | 280 CV / 206 kW |
| Displacement | 3500 cc |
| Fuel | Benzina aspirato |
| Vehicle type | Auto |
ECU
| Manufacturer | DENSO |
| Model | 275036-2110 |
| Memory / EPROM | MICRO NEC 76F0038AGD - 6144 Kbit - C0000 |
Available tuning operations / options:
- Spark advance correction for ECT sensor
- Requested spark advance - high octane
- Requested spark advance - low octane
- Spark advance correction - valve timing position 1
- Spark advance correction - valve timing position 2
- Electronic throttle control
- Electronic throttle control 2
- Electronic throttle control 3
- Lambda correction f(IAT)
- Lambda correction f(ECT)
- Lambda correction f(ECT) 2
- Lambda correction f(ECT) 3
- Gearbox maximum torque allowed
- Advance limiter for component protection 1
- Torque limiter
- Lambda enrichment - open loop
- RPM Limiter
- Lambda driver wish
- Speed limiter
- % relative air filling limit depending on IAT
- Driver torque request
- Exhaust gas temperature sensor
- Variable valve timing - inlet
- Variable valve timing - outlet
Firmware identifiers (5)
| Hardware No. | Software No. (chip) | Version | Update software | ECU |
|---|
| — | 89663-33653- |
1.51.010 | 33365300 |
DENSO 275036-2110 |
| — | 89663-06630-A |
1.51.057 | 30663000 |
DENSO 275036-2110 |
| — | 89663-YW300- |
1.51.032 | 3YW30000 |
DENSO 275036-2110 |
| — | 89663-33651- |
1.51.006 | 33365100 |
DENSO 275036-2110 |
| — | 89663-33652- |
1.51.013 | 33365200 |
DENSO 275036-2110 |
Vehicle technical notes
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.
ECU notes
Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Get the file for this vehicle
Tools to read and write this ECU
