TOYOTA ALPHARD/VELLFIRE (AH20) 3.5L V6 24V 206kW/276HP DENSO

ECU DENSO 275036-2110 · 280 CV (206 kW) · 3500 cc · Benzina aspirato

ECU DatabaseTOYOTA › TOYOTA ALPHARD/VELLFIRE (AH20) 3.5L V6 24V 206kW/276HP DENSO

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 7 firmware versions

Vehicle data

BrandTOYOTA
ModelALPHARD/VELLFIRE (AH20)
Engine3.5L V6 24V 206kW/276HP DENSO
Stock power280 CV / 206 kW
Displacement3500 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerDENSO
Model275036-2110
Memory / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Available tuning operations / options:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Lambda correction f(ECT) 3
  • Gearbox maximum torque allowed
  • Advance limiter for component protection 1
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware identifiers (7)

Hardware No.Software No. (chip)VersionUpdate softwareECU
89663-58101- 1.51.01735810100 DENSO 275036-2110
89663-58480- 1.51.01735848000 DENSO 275036-3560
89663-58250-A 1.67.01835825000 DENSO 275036-4520
89663-58260- 1.67.00435826000 DENSO 275036-4520
89663-58100-A 1.51.00735810000 DENSO 275036-4520
89663-58201- 1.67.00835820100 DENSO 275036-4520
89663-58231- 1.67.00735823100 DENSO 275036-4520

Vehicle technical notes

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU notes

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata