Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.
✓ Tuning via file (flash)
1 firmware versions
Vehicle data
| Brand | PEUGEOT |
| Model | 4008 |
| Engine | 1.6L 16V HDI 85kW/114HP SID807EVO |
| Stock power | 116 CV / 85 kW |
| Displacement | 1600 cc |
| Fuel | Diesel sovralimentato |
| Vehicle type | Auto |
ECU
| Manufacturer | CONTINENTAL-SIEMENS-VDO |
| Model | SID807EVO |
| Memory / EPROM | MICRO ST TRICORE - 32768 Kbit - 400000 |
Available tuning operations / options:
- Boost pressure limiter for diagnostics
- Boost pressure limiter
- BAP setpoint limitation depending on before particulate filter pressure in aftertreatment modes
- Boost pressure
- Boost pressure 2
- Boost pressure 3
- Boost pressure 4
- Load / throttle position reference
- Exhaust gas temperature value before turbine in regeneration mode
- Exhaust gas temperature value before turbine in regular injection mode
- Basic torque management at engine cranking
- Injection opening time related to inj. pressure
- J
- Torque limiter 2
- Torque limiter
- Intake manifold pressure
- Throttle air mass flow calculation
- Throttle air mass flow calculation 2
- Max torque profile
- Specific injection pressure limiter
- Specific injection pressure
- Driver torque request for high speed
- Driver torque request for medium speed
- Driver torque request for low speed
- Driver torque request at the start
- Driver torque request for reverse gear
- Torque limiter for EFT sensor
- Torque limit table for ECT sensor
- Variable geometry duty cycle limit
Firmware identifiers (1)
| Hardware No. | Software No. (chip) | Version | Update software | ECU |
|---|
| 9675411580 | 9678226080 |
1.83.011 | 9692020480 |
CONTINENTAL-SIEMENS-VDO SID807EVO |
Vehicle technical notes
OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.
ECU notes
MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Get the file for this vehicle
Tools to read and write this ECU
