Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.
✓ Tuning via file (flash)
✓ Add-on module available 4 firmware versions
Vehicle data
| Brand | PEUGEOT |
| Model | 208 |
| Engine | 1.4L 8V HDI 54kW/72HP EDC17C10 |
| Stock power | 73 CV / 54 kW |
| Displacement | 1400 cc |
| Fuel | Diesel sovralimentato |
| Vehicle type | Auto |
ECU
| Manufacturer | BOSCH |
| Model | EDC17C10 |
| Memory / EPROM | MICRO ST TRICORE - 32768 Kbit - 400000 |
Available tuning operations / options:
- Boost pressure limiter
- Boost pressure limiter 2
- Maximum engine boost pressure F (atmospheric pressure)
- Boost pressure
- Boost pressure 2
- EGR valve control
- Exhaust gas temperature
- Exhaust gas temperature 2
- Injection opening time related to inj. pressure
- Torque limiter 2
- Torque limiter
- Torque limiter for diagnostic
- Torque limiter for smoke limitation
- Specific injection pressure limiter
- Specific injection pressure limiter 2
- Specific injection pressure limiter 3
- Specific injection pressure limiter for EFT sensor
- Specific injection pressure
- Specific injection pressure 2
- Driver torque request
- Driver torque request for high speed
- Driver torque request for low speed
- Driver torque request at the start
- Driver torque request for reverse gear
- Torque limiter for EFT sensor
- Torque limit table for ECT sensor
Firmware identifiers (4)
| Hardware No. | Software No. (chip) | Version | Update software | ECU |
|---|
| 9666077280 | 9666729680 |
1.94.017 | 9679121080 |
BOSCH EDC17C10 |
| 9666077280 | 9666729680 |
1.94.018 | 9679080580 |
BOSCH EDC17C10 |
| 9666077280 | 9666729680 |
1.94.014 | 9691575280 |
BOSCH EDC17C10 |
| 9666077280 | 9666729680 |
1.94.015 | 9679080480 |
BOSCH EDC17C10 |
Vehicle technical notes
OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.
ECU notes
MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Get the file for this vehicle
Tools to read and write this ECU
