VOLKSWAGEN GOLF 7 (A7) 1.0L L3 12V TSI 63kW/85HP MED17.1.27

ECU BOSCH MED17.1.27 · 86 CV (63 kW) · 1000 cc · Benzina sovralimentato

ECU DatabaseVOLKSWAGEN › VOLKSWAGEN GOLF 7 (A7) 1.0L L3 12V TSI 63kW/85HP MED17.1.27

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandVOLKSWAGEN
ModelGOLF 7 (A7)
Engine1.0L L3 12V TSI 63kW/85HP MED17.1.27
Stock power86 CV / 63 kW
Displacement1000 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.1.27
Memory / EPROMMICRO ST TRICORE - 32768 - 400000

Available tuning operations / options:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Boost pressure limiter
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Gearbox maximum torque allowed
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum compression ratio
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
1.94.01204C906025N 6250 BOSCH MED17.1.27

ECU notes

MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata