VOLKSWAGEN GOLF 6 (A6) 2.0L 16V TSI GTI 147kW/197HP MED17

ECU BOSCH MED17.1 · 200 CV (147 kW) · 2000 cc · Benzina sovralimentato

ECU DatabaseVOLKSWAGEN › VOLKSWAGEN GOLF 6 (A6) 2.0L 16V TSI GTI 147kW/197HP MED17

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 20 firmware versions

Vehicle data

BrandVOLKSWAGEN
ModelGOLF 6 (A6)
Engine2.0L 16V TSI GTI 147kW/197HP MED17
Stock power200 CV / 147 kW
Displacement2000 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.1
Memory / EPROMMICRO ST TRICORE - 16384 Kbit - 200000

Available tuning operations / options:

  • Engine ignition timing versus temperature
  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Filling factor limit
  • Filling factor limit 2
  • Factor for reducing maximum filling
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • Engine speed limitation at high motor temperature
  • Engine speed limit temperature based
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum boost pressure load
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation 2
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Throttle angle management

Firmware identifiers (20)

Hardware No.Software No. (chip)VersionUpdate softwareECU
1.94.0211K0907115AL 0030 BOSCH MED17.1
1.94.0121K0907115AT 0040 BOSCH MED17.1
1.94.0071K0907115AQ 0040 BOSCH MED17.1
1.94.0341K0907115AT 0010 BOSCH MED17.1
1.94.0081K0907115AQ 0030 BOSCH MED17.1
1.94.0098P0907115BC 0020 BOSCH MED17.1
1.94.0351K0907115AT 0020 BOSCH MED17.1
1.94.0021K0907115AL 0020 BOSCH MED17.1
0261S043781037396277 1.94.0081K0907115AF 0010 BOSCH MED17.1
1.94.0091K0907115AS 0020 BOSCH MED17.5
1.94.0128P0907115AM 0020 BOSCH MED17.5
1.94.0151K0907115AS 0040 BOSCH MED17.5
1.94.0111K0907115AS 0010 BOSCH MED17.5
1.94.0201K0907115AM 0030 BOSCH MED17.5
1.94.0321K8907115 0030 BOSCH MED17.5
1.94.0291K8907115 0020 BOSCH MED17.5
1.94.0041K0907115AP 0030 BOSCH MED17.5
1.94.0068P0907115BB 0020 BOSCH MED17.5
1.94.0131K0907115AP 0020 BOSCH MED17.5
1.94.0041K0907115AP 0040 BOSCH MED17.5

ECU notes

MICRO Infineon Tricore TC1766 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata
MICRO Infineon Tricore TC1796 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Add-on modules available

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop