VOLKSWAGEN CC 3.0L V6 FSI 184kW/247HP MED17.1.6

ECU BOSCH MED17.1.6 · 250 CV (184 kW) · 3000 cc · Benzina aspirato

ECU DatabaseVOLKSWAGEN › VOLKSWAGEN CC 3.0L V6 FSI 184kW/247HP MED17.1.6

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 4 firmware versions

Vehicle data

BrandVOLKSWAGEN
ModelCC
Engine3.0L V6 FSI 184kW/247HP MED17.1.6
Stock power250 CV / 184 kW
Displacement3000 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.1.6
Memory / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Available tuning operations / options:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system 2
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • LG/V
  • RPM Limiter 2
  • RPM limiter 3
  • RPM limiter 4
  • RPM Limiter 5
  • RPM Limiter 6
  • Lambda driver wish
  • Knock detection factor
  • MAF sensor calibration
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Torque limiter for selected gear
  • Throttle angle management

Firmware identifiers (4)

Hardware No.Software No. (chip)VersionUpdate softwareECU
1.94.01303H906023AD 2767 BOSCH MED17.1.6
1.94.01103H906023CH 5753 BOSCH MED17.1.6
1.94.00603H906023CN 7134 BOSCH MED17.1.6
1.94.00603H906023S 2766 BOSCH MED17.1.6

ECU notes

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata