SKODA SUPERB (B6) 3.6L V6 24V FSI 191kW/260HP MED17.1.6

ECU BOSCH MED17.1.6 · 260 CV (191 kW) · 3600 cc · Benzina aspirato

ECU DatabaseSKODA › SKODA SUPERB (B6) 3.6L V6 24V FSI 191kW/260HP MED17.1.6

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 3 firmware versions

Vehicle data

BrandSKODA
ModelSUPERB (B6)
Engine3.6L V6 24V FSI 191kW/260HP MED17.1.6
Stock power260 CV / 191 kW
Displacement3600 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.1.6
Memory / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Available tuning operations / options:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system 2
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • LG/V
  • RPM Limiter 2
  • RPM limiter 3
  • RPM limiter 4
  • RPM Limiter 5
  • RPM Limiter 6
  • Lambda driver wish
  • Knock detection factor
  • MAF sensor calibration
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Torque limiter for selected gear
  • Throttle angle management

Firmware identifiers (3)

Hardware No.Software No. (chip)VersionUpdate softwareECU
1.94.00603H906023AE 4271 BOSCH MED17.1.6
1.00.06203H906023AE 1642 BOSCH MED17.1.6
1.94.00603H906023CF 5770 BOSCH MED17.1.6

ECU notes

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Add-on modules available

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop