SKODA FABIA Mk1 (6Y) 2.0L 8V 85kW/114HP ME7.5

ECU BOSCH ME7.5 · 116 CV (85 kW) · 2000 cc · Benzina aspirato

ECU DatabaseSKODA › SKODA FABIA Mk1 (6Y) 2.0L 8V 85kW/114HP ME7.5

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandSKODA
ModelFABIA Mk1 (6Y)
Engine2.0L 8V 85kW/114HP ME7.5
Stock power116 CV / 85 kW
Displacement2000 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelME7.5
Memory / EPROM29F800 PSOP44 8Mbit - Flash 512K x 16

Available tuning operations / options:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Lambda enrichment for components protection
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation 2
  • Driver torque request
  • Driver torque request for reverse gear
  • Throttle angle management
  • Variable intake pulsation correction

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
02612082791037367539 1.21.00906A906032PQ 1201 BOSCH ME7.5

ECU notes

Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator. This Setting File can be used for serial system : Genius or NewGenius. To work on this ECU you can use NewTrasdata