Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.
✓ Tuning via file (flash)
✓ Add-on module available 1 firmware versions
Vehicle data
| Brand | SEAT |
| Model | EXEO |
| Engine | 2.0L 16V TSI 147kW/197HP MED17.1 |
| Stock power | 200 CV / 147 kW |
| Displacement | 2000 cc |
| Fuel | Benzina sovralimentato |
| Vehicle type | Auto |
ECU
| Manufacturer | BOSCH |
| Model | MED17.1 |
| Memory / EPROM | MICRO ST TRICORE - 16384 Kbit - 200000 |
Available tuning operations / options:
- Engine ignition timing versus temperature
- Base timing
- Advance at idle speed
- Optimal spark timing/MBT
- Height correction for boost pressure
- Desired engine load calculation
- Lambda correction for engine temperature after starting
- Maximum pressure ratio limit for diagnosis
- Exhaust gas temperature
- Factor to correct fuel delivery system
- Filling factor limit
- Filling factor limit 2
- Factor for reducing maximum filling
- High pressure fuel pump setpoint
- High fuel pressure pump limit for ECT sensor
- Lambda enrichment for components protection
- Lambda correction for exhaust manifold temperature
- RPM Limiter
- RPM Limiter 2
- RPM limiter 3
- Engine speed limitation at high motor temperature
- Engine speed limit temperature based
- Lambda driver wish
- Knock detection factor
- Speed limiter
- Maximum boost pressure load
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Optimal engine moment
- Power limit torque table
- Relative permissible torque from the pedal position in torque limitation
- Relative permissible torque from the pedal position in torque limitation 2
- Pressure ratio depending on IAT
- Maximum pressure ratio limit depending on temperature
- Driver torque request
- Throttle angle management
Firmware identifiers (1)
| Hardware No. | Software No. (chip) | Version | Update software | ECU |
|---|
| — | — |
1.94.021 | 3R0907115J 0020 |
BOSCH MED17.1 |
ECU notes
MICRO Infineon Tricore TC1796 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Get the file for this vehicle
Tools to read and write this ECU
