PORSCHE CAYMAN (987) 2.9L DFI Mk2 155kW/208HP ME7.8.2

ECU BOSCH ME7.8.2 min · 211 CV (155 kW) · 2900 cc · Benzina aspirato

ECU DatabasePORSCHE › PORSCHE CAYMAN (987) 2.9L DFI Mk2 155kW/208HP ME7.8.2

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandPORSCHE
ModelCAYMAN (987)
Engine2.9L DFI Mk2 155kW/208HP ME7.8.2
Stock power211 CV / 155 kW
Displacement2900 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelME7.8.2 min
Memory / EPROM29F800 PSOP44 8Mbit - Flash 512K x 16

Available tuning operations / options:

  • Base timing
  • Minimum advance allowed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Factor to correct fuel delivery system 2
  • HFM/HLM air flow high limit
  • HFM/HLM air flow low limit
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Lambda efficiency
  • RPM Limiter
  • RPM Limiter 2
  • Lambda driver wish
  • Knock detection factor
  • MAF sensor calibration
  • Maximum ignition delay allowed for knock limiter intervention
  • Throttle air mass flow calculation
  • Minimum engine air charge value
  • Number of injections considered for knock limitation
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation - sport/race mode
  • Driver wish
  • Driver torque request
  • Maximum threshold for detecting engine knock - bank 1
  • Maximum threshold for detecting engine knock - bank 2
  • Throttle angle management
  • Variable intake pulsation correction

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
026120134900419100C440 1.87.02600419100C440NM72 BOSCH ME7.8.2 min

ECU notes

Microprocessor ST10F275 Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION!