Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.
✓ Tuning via file (flash)
✓ Add-on module available 4 firmware versions
Vehicle data
| Brand | PORSCHE |
| Model | CAYENNE (9YA) |
| Engine | 3.0L V6 24V TURBO E-HYBRID 340kW/456HP MG1CS002 |
| Stock power | 462 CV / 34 kW |
| Displacement | 3000 cc |
| Fuel | Hybrid |
| Vehicle type | Auto |
ECU
| Manufacturer | BOSCH |
| Model | MG1CS002 |
| Memory / EPROM | Micro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte |
Available tuning operations / options:
- Base timing
- Advance at idle speed
- Optimal spark timing/MBT
- Optimal spark timing/MBT 2
- Lambda correction for engine temperature after starting
- Compression ratio for turbocharger protection
- Compression ratio limiting for compressor depending on IAT sensor
- Exhaust gas temperature
- Factor for reducing maximum filling
- Torque limiter 2
- Torque limiter 3
- Torque limiter 4
- Torque limiter 5
- Torque limiter 6
- Torque limiter
- Lambda enrichment for components protection
- Lambda correction for exhaust manifold temperature
- Engine speed limit temperature based
- Lambda driver wish
- Knock detection factor
- Speed limiter
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Max torque profile
- Max torque profile - MT
- Optimal engine moment
- Power limit torque table
- % relative air filling limit depending on IAT
- Driver torque request
- Driver torque request 2
- Driver torque request Sport mode
- Turbocharger volumetric efficiency
Firmware identifiers (4)
| Hardware No. | Software No. (chip) | Version | Update software | ECU |
|---|
| — | — |
1.02.010 | 9Y0907559AE 0002 |
BOSCH MG1CS002 |
| — | — |
1.02.006 | 9Y0907559B 0004 |
BOSCH MG1CS002 |
| — | — |
1.02.013 | 9Y0907559J 0003 |
BOSCH MG1CS002 |
| — | — |
1.02.009 | 9Y0907551A 0005 |
BOSCH MG1CS002 |
ECU notes
Microprocessor BGA FREESCALE SPC57xxx This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Get the file for this vehicle
Tools to read and write this ECU
