PORSCHE 991.2 4.0L GT3 368kW/494HP MED17.1.11

ECU BOSCH MED17.1.11 · 500 CV (368 kW) · 4000 cc · Benzina aspirato

ECU DatabasePORSCHE › PORSCHE 991.2 4.0L GT3 368kW/494HP MED17.1.11

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 11 firmware versions

Vehicle data

BrandPORSCHE
Model991.2
Engine4.0L GT3 368kW/494HP MED17.1.11
Stock power500 CV / 368 kW
Displacement4000 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.1.11
Memory / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Available tuning operations / options:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Driver torque request 2
  • Torque limiter for selected gear
  • Throttle angle management

Firmware identifiers (11)

Hardware No.Software No. (chip)VersionUpdate softwareECU
1.94.00499161867717 3676 BOSCH MED17.1.11
1.94.00399161869017 3669 BOSCH MED17.1.11
1.94.00599161865617 3668 BOSCH MED17.1.11
1.94.00499161865917 3674 BOSCH MED17.1.11
1.94.00599161865717 3670 BOSCH MED17.1.11
1.94.00399161869417 3673 BOSCH MED17.1.11
1.94.00499161869216 3625 BOSCH MED17.1.11
1.94.00499161869217 3671 BOSCH MED17.1.11
1.94.00999161865615 3582 BOSCH MED17.1.11
1.94.00399161865616 3622 BOSCH MED17.1.11
1.94.00599161865716 3624 BOSCH MED17.1.11

ECU notes

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata