MERCEDES GLK CLASS X204 GLK300 3.0L V6 170kW/228HP ME9.7

ECU BOSCH ME9.7 · 231 CV (17 kW) · 3000 cc · Benzina aspirato

ECU DatabaseMERCEDES › MERCEDES GLK CLASS X204 GLK300 3.0L V6 170kW/228HP ME9.7

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 6 firmware versions

Vehicle data

BrandMERCEDES
ModelGLK CLASS X204
EngineGLK300 3.0L V6 170kW/228HP ME9.7
Stock power231 CV / 17 kW
Displacement3000 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelME9.7
Memory / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Available tuning operations / options:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • HFM/HLM threshold for diagnosis
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware identifiers (6)

Hardware No.Software No. (chip)VersionUpdate softwareECU
00344677402729020000 1.79.0042729033000 BOSCH ME9.7
00344677402729020900 1.79.0072729035000 BOSCH ME9.7
00344677402729020900 1.79.002381B22B152 BOSCH ME9.7
00344677402729020000 1.79.0062729033800 BOSCH ME9.7
00344677400104481840 1.79.0230074471340 BOSCH ME9.7
00344677402729020900 1.79.0082729034200 BOSCH ME9.7

ECU notes

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Add-on modules available

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop