MERCEDES CLK CLASS C209/A209 CLK280 3.0L V6 170kW/228HP ME9.7

ECU BOSCH ME9.7 · 231 CV (17 kW) · 3000 cc · Benzina aspirato

ECU DatabaseMERCEDES › MERCEDES CLK CLASS C209/A209 CLK280 3.0L V6 170kW/228HP ME9.7

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 5 firmware versions

Vehicle data

BrandMERCEDES
ModelCLK CLASS C209/A209
EngineCLK280 3.0L V6 170kW/228HP ME9.7
Stock power231 CV / 17 kW
Displacement3000 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelME9.7
Memory / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Available tuning operations / options:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • HFM/HLM threshold for diagnosis
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware identifiers (5)

Hardware No.Software No. (chip)VersionUpdate softwareECU
00244673400024486040 1.79.0130024471140 BOSCH ME9.7
00244673400094489240 1.79.0120064475540 BOSCH ME9.7
00244673400054487040 1.79.0090044476140 BOSCH ME9.7
00344676400054481240 1.79.0040034477140 BOSCH ME9.7
00344676400054487040 1.79.0120034478640 BOSCH ME9.7

ECU notes

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata