LINCOLN NAUTILUS 2.7L EcoBoost 237kW/318HP MG1CS019

ECU BOSCH MG1CS019 · 322 CV (237 kW) · 2700 cc · Benzina sovralimentato

ECU DatabaseLINCOLN › LINCOLN NAUTILUS 2.7L EcoBoost 237kW/318HP MG1CS019

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandLINCOLN
ModelNAUTILUS
Engine2.7L EcoBoost 237kW/318HP MG1CS019
Stock power322 CV / 237 kW
Displacement2700 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMG1CS019
Memory / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte

Available tuning operations / options:

  • Base timing
  • Desired engine load calculation
  • Part pedal combustion load limit
  • Exhaust gas temperature
  • Engine indicated torque
  • Engine indicated torque at stoichiometric
  • Factor to correct fuel delivery system
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Load limit at high effectiveness of LSPI mitigation
  • Load limit at low effectiveness of LSPI mitigation
  • Load limit at nominal effectiveness of LSPI mitigation
  • Maximum throttle angle opening for a given RPM
  • Overall LSPI load limit
  • Percent accelerator pedal angle to desired throttle angle
  • Final drive rear axle ratio
  • Driver torque request for the transmission - 1st gear
  • Driver torque request for the transmission - 2th gear
  • Driver torque request for the transmission - 3th gear
  • Driver torque request for the transmission - 4th gear
  • Maximum rear axle ratio
  • Minimum rear axle ratio
  • Driver torque request
  • Driven tire circumference
  • Maximum tire circumference
  • Minimum tire circumference

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
K2GA-12B684-AAK2GA-12A650-AHA 1.94.011K2GA-14C204-DEB BOSCH MG1CS019

ECU notes

Micro Infineon Tricore TC298TP This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata