KAWASAKI Z 900 RS 18->20 82kW

ECU DENSO 21175-1312/1315 · 111 CV (82 kW) · 948 cc · Benzina aspirato

ECU DatabaseKAWASAKI › KAWASAKI Z 900 RS 18->20 82kW

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 3 firmware versions

Vehicle data

BrandKAWASAKI
ModelZ 900 RS
Engine18->20 82kW
Stock power111 CV / 82 kW
Displacement948 cc
FuelBenzina aspirato
Vehicle typeMoto

ECU

ManufacturerDENSO
Model21175-1312/1315
Memory / EPROMMicro RENESAS - 8192 Kbit -100000

Available tuning operations / options:

  • Base timing - full power
  • Base timing - low power
  • Base timing - clutch/neutral
  • Load / throttle position reference
  • Exhaust valve management in deceleration - gear based - full power
  • Exhaust valve management in deceleration - gear based - low power
  • Exhaust valve management - gear based - full power
  • Exhaust valve management - gear based - low power
  • Engine idle vs. ECT sensor
  • Injection for IAP - full power
  • Injection for IAP - low power
  • Injection for TPS - full power
  • Injection for TPS - low power
  • RPM Limiter
  • RPM Limiter 2
  • Ram Air
  • Secondary throttle plates management in deceleration - gear based - full power
  • Secondary throttle plates management in deceleration - gear based - low power
  • Secondary throttle plates management - gear based - full power
  • Secondary throttle plates management - gear based - low power
  • Cooling fan activation
  • Traction control - activation sensitivity
  • Traction control - slip sensitivity
  • Traction control - TPS correction

Firmware identifiers (3)

Hardware No.Software No. (chip)VersionUpdate softwareECU
21175-1315KNJ4KPJ0 1.00.00449245-1262 DENSO 21175-1312/1315
21175-1322KNJ2KPS0 1.00.00449245-1265 DENSO 21175-1322/1323
21175-1323KNJ2KPH0 1.00.00349245-1266 DENSO 21175-1322/1323

ECU notes

Microprocessor SH7058 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata