FORD ECOSPORT (B515) Mk2 1.0L 12V Ecoboost 74kW/99HP MED17.2

ECU BOSCH MED17.2 · 101 CV (74 kW) · 1000 cc · Benzina sovralimentato

ECU DatabaseFORD › FORD ECOSPORT (B515) Mk2 1.0L 12V Ecoboost 74kW/99HP MED17.2

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandFORD
ModelECOSPORT (B515) Mk2
Engine1.0L 12V Ecoboost 74kW/99HP MED17.2
Stock power101 CV / 74 kW
Displacement1000 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.2
Memory / EPROMMICRO ST TRICORE - 16384 Kbit - 200000

Available tuning operations / options:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Desired pressure ratio
  • Exhaust gas temperature
  • Exhaust gas temperature 2
  • High pressure fuel pump setpoint
  • High pressure fuel pump setpoint 2
  • Injection period
  • Injection correction
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • RPM limit for ECT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Boost pressure threshold cycles for the overboost recognition
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Turbocharger volumetric efficiency
  • Wastegate duty-cycle

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
E1BA-12B684-AA1037550308 1.94.002FT7A-14C204-KA BOSCH MED17.2

ECU notes

MICRO Infineon Tricore TC1767 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata