FORD TRUCK F-350 6.2L V8 32V 287kW/385HP MG1CS019

ECU BOSCH MG1CS019 · 390 CV (287 kW) · 6200 cc · Benzina aspirato

ECU DatabaseFORD TRUCK › FORD TRUCK F-350 6.2L V8 32V 287kW/385HP MG1CS019

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandFORD TRUCK
ModelF-350
Engine6.2L V8 32V 287kW/385HP MG1CS019
Stock power390 CV / 287 kW
Displacement6200 cc
FuelBenzina aspirato
Vehicle typeLCV

ECU

ManufacturerBOSCH
ModelMG1CS019
Memory / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte

Available tuning operations / options:

  • Base timing
  • Desired engine load calculation
  • Part pedal combustion load limit
  • Engine indicated torque
  • Engine indicated torque at stoichiometric
  • Factor to correct fuel delivery system
  • RPM Limiter
  • Load limit at high effectiveness of LSPI mitigation
  • Load limit at low effectiveness of LSPI mitigation
  • Load limit at nominal effectiveness of LSPI mitigation
  • Maximum throttle angle opening for a given RPM
  • Overall LSPI load limit
  • Percent accelerator pedal angle to desired throttle angle
  • Final drive rear axle ratio
  • Driver torque request for the transmission - 1st gear
  • Driver torque request for the transmission - 2th gear
  • Driver torque request for the transmission - 3th gear
  • Driver torque request for the transmission - 4th gear
  • Driver torque request for the transmission - 5th gear
  • Driver torque request for the transmission - 6th gear
  • Maximum rear axle ratio
  • Minimum rear axle ratio
  • Driver torque request
  • Driver torque request for reverse gear
  • Driven tire circumference
  • Maximum tire circumference
  • Minimum tire circumference

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
LC3A-12B684-JALC3A-12A650-ANA 1.94.009LC3A-14C204-CEC BOSCH MG1CS019

ECU notes

Micro Infineon Tricore TC298TP This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata