FIAT PANDA (319) 0.9L 8V TWINAIR 48kW/65HP IAW8GMF

ECU MARELLI 8GMB/8GMC/8GMF/8GMW/8GSF/8GSW · 65 CV (48 kW) · 900 cc · Benzina aspirato

ECU DatabaseFIAT › FIAT PANDA (319) 0.9L 8V TWINAIR 48kW/65HP IAW8GMF

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 1 firmware versions

Vehicle data

BrandFIAT
ModelPANDA (319)
Engine0.9L 8V TWINAIR 48kW/65HP IAW8GMF
Stock power65 CV / 48 kW
Displacement900 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerMARELLI
Model8GMB/8GMC/8GMF/8GMW/8GSF/8GSW
Memory / EPROMMICRO BGA MOTOROLA FRESCALE con Flash interna MPC5565 16384 Kbit - 0x200000

Available tuning operations / options:

  • Spark advance during acceleration
  • Advance at part load
  • Advance correction
  • Base lambda - cold
  • Base Lambda - hot
  • Boost pressure limiter
  • Electronic throttle control
  • Compressor pressure ratio limit for pumping and speed
  • Average power effective limitation
  • Average torque effective limitation
  • Advance limiter
  • Basic value setpoint Lambda sensor
  • RPM Limiter
  • RPM Limiter 2
  • Maximum Upstream pressure in event of Normal boost modality
  • Maximum Upstream pressure in event of normal boost modality, Sport mode activated
  • Maximum Upstream pressure in event of overboost modality
  • Maximum Upstream pressure in event of overboost modality, Sport modality activated
  • Max torque profile
  • Torque management Sport mode
  • Power Control in Normal mode
  • Power Control in Sport mode
  • Resistant torque table
  • Take-off torque law in Normal mode
  • Take-off torque law in Normal mode with power control
  • Take-off torque law in Sport mode
  • Take-off torque law in Sport mode with power control
  • Wastegate duty-cycle

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
MM8GSWHW601D432BM3W 1.91.013 MARELLI 8GMB/8GMC/8GMF/8GMW/8GSF/8GSW

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

Microprocessor FMPC 5565 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual.

Add-on modules available

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop