FIAT 500 (312) 1.4L 16V MULTIAIR 75kW/101HP IAW8GMKC

ECU MARELLI 8GMK/8GML · 102 CV (75 kW) · 1400 cc · Benzina aspirato

ECU DatabaseFIAT › FIAT 500 (312) 1.4L 16V MULTIAIR 75kW/101HP IAW8GMKC

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandFIAT
Model500 (312)
Engine1.4L 16V MULTIAIR 75kW/101HP IAW8GMKC
Stock power102 CV / 75 kW
Displacement1400 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerMARELLI
Model8GMK/8GML
Memory / EPROMMicro BGA STSPC564A80 - 32748Kbit - 400000

Available tuning operations / options:

  • Base timing
  • Base lambda - cold
  • Base Lambda - hot
  • Boost pressure limiter
  • Electronic throttle control
  • Compressor pressure ratio limit for pumping and speed
  • Average power effective limitation
  • Average torque effective limitation
  • Torque limiter
  • Maximum Upstream pressure in event of Normal boost modality
  • Maximum Upstream pressure in event of normal boost modality, Offroad mode activated
  • Maximum Upstream pressure in event of normal boost modality, Sport mode activated
  • Maximum Upstream pressure in event of overboost modality
  • Maximum Upstream pressure in event of overboost modality, Offroad modality activated
  • Maximum Upstream pressure in event of overboost modality, Sport modality activated
  • Max torque profile
  • Torque management in Normal mode
  • Torque management Sport mode
  • Power Control in Normal mode
  • Power Control in Sport mode
  • Power limit torque table
  • Torque limit table for ECT sensor
  • Take-off torque law in Normal mode
  • Take-off torque law in Normal mode with power control
  • Take-off torque law in Sport mode
  • Take-off torque law in Sport mode with power control
  • Wastegate duty-cycle

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
MM8GMKHW66608020000 1.91.01308020000 MARELLI 8GMK/8GML

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

Microprocessor BGA SPC564A80 This Setting File can be used for serial system NewGenius. ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual. To work on this ECU you can use NewTrasdata