CMC CIRELLI 5 1.5L TURBO 130kW/174HP MG1US008

ECU BOSCH MG1US008 · 177 CV (13 kW) · 1500 cc · Benzina sovralimentato

ECU DatabaseCMC › CMC CIRELLI 5 1.5L TURBO 130kW/174HP MG1US008

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 2 firmware versions

Vehicle data

BrandCMC
ModelCIRELLI 5
Engine1.5L TURBO 130kW/174HP MG1US008
Stock power177 CV / 13 kW
Displacement1500 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMG1US008
Memory / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 384Kbyte

Available tuning operations / options:

  • Base timing
  • Knock correction advance max
  • Desired engine load calculation
  • Lambda correction
  • Lambda Correction 2
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Exhaust gas temperature
  • Exhaust gas temperature 2
  • Factor to correct fuel delivery system
  • Factor for reducing maximum filling
  • Advance limiter for component protection 1
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile (overboost active)
  • Optimal engine moment
  • Power limit torque table
  • Driver torque request
  • Torque limiter for selected gear
  • Throttle angle management
  • Turbocharger volumetric efficiency

Firmware identifiers (2)

Hardware No.Software No. (chip)VersionUpdate softwareECU
F01R00DU7Z 1.94.002ZH1107AQ03 BOSCH MG1US008
F01R00DU7Z 1.94.008ZH1107AP08 BOSCH MG1US008

Vehicle technical notes

ECU located in the engine bay behind/close to the battery. Difficulty: easy

ECU notes

This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata