CAN-AM/BRP MAVERICK Xds 1000 16->19 88kW

ECU BOSCH ME17.8.5 · 120 CV (88 kW) · 1000 cc · Benzina sovralimentato

ECU DatabaseCAN-AM/BRP › CAN-AM/BRP MAVERICK Xds 1000 16->19 88kW

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 5 firmware versions

Vehicle data

BrandCAN-AM/BRP
ModelMAVERICK Xds 1000
Engine16->19 88kW
Stock power120 CV / 88 kW
Displacement1000 cc
FuelBenzina sovralimentato
Vehicle typeMoto

ECU

ManufacturerBOSCH
ModelME17.8.5
Memory / EPROMMICRO ST TRICORE - 12032 Kbit - 178000

Available tuning operations / options:

  • Base timing
  • Lambda/AFR mixture for engine temperature at crancking
  • Optimal spark timing/MBT
  • Boost pressure limit control
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Desired pressure ratio
  • Exhaust gas temperature
  • Expected vehicle speed
  • ECT for fan disengagement
  • ECT for fan engagement
  • INJLC
  • Injector latency - cylinder 2
  • INJSC
  • Injector scaling - cylinder 2
  • Torque limiter
  • RPM Limiter
  • RPM Limiter 2
  • Gear dependent maximum engine speed
  • RPM limiter in limp mode
  • Maximum limitation Lambda sensor
  • Speed limiter based on gear
  • Speed limiter for key
  • Speed limiter - rear axle protection
  • Speed limiter for unknown gear
  • Map sensor offset
  • MAP sensor slope
  • Max MAP sensor voltage
  • Throttle air mass flow calculation
  • Min MAP sensor voltage
  • Max allowed torque for speed limit control
  • Optimal engine moment
  • RPM hysteresis above rev limit for fuel cut-off
  • Driver torque request
  • Torque limit table for IAT sensor
  • Torque limit for voltage
  • Target Lambda for knock protection
  • Torque limit table for ECT sensor
  • Volumetric efficiency
  • RPM threshold for 2 foot
  • Vehicle speed threshold for 2 foot
  • WG duty cycle vs RPM and boost

Firmware identifiers (5)

Hardware No.Software No. (chip)VersionUpdate softwareECU
F00HM001817E1142OD9VMS9 1.94.013 BOSCH ME17.8.5
F00HM001817E1142QD9VMS4 1.94.011 BOSCH ME17.8.5
F00HM001817E1142OD9VMSA 1.94.019 BOSCH ME17.8.5
F00HM001967E2163OG2VLS2 1.94.011 BOSCH ME17.8.5
F00HM001967E2175NL6VJS1 1.94.003 BOSCH ME17.8.5

ECU notes

MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata