AUDI TT (8S/FV) 2.0L 16V TFSI 180kW/242HP DSG DQ381

ECU BOSCH DQ381 · 245 CV (18 kW) · 2000 cc · Benzina sovralimentato

ECU DatabaseAUDI › AUDI TT (8S/FV) 2.0L 16V TFSI 180kW/242HP DSG DQ381

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandAUDI
ModelTT (8S/FV)
Engine2.0L 16V TFSI 180kW/242HP DSG DQ381
Stock power245 CV / 18 kW
Displacement2000 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelDQ381
Memory / EPROMMicro Renesas - 20480 Kbit

Available tuning operations / options:

  • Gear upshift 1->2
  • Gear upshift 2->3
  • Maximum time for gear downshift
  • Time shift
  • Time shift with torque reduction
  • Time shift with torque reduction 2
  • Maximum torque limitation at clutch
  • Clutch torque reduction factor
  • Gearbox torque limiter
  • Gearbox torque limiter 2
  • Maximum torque reduction in ECO (D)
  • Maximum torque reduction during launch control
  • Maximum torque reduction in MANUAL
  • Maximum torque reduction in SPORT (S)
  • RPM limiter
  • RPM limiter - N
  • RPM limiter - R
  • Maximum torque allowed for gear upshift
  • Gearbox torque limiter for ECT sensor
  • Engine torque limiter depending on vehicle speed
  • Maximum allowable oil pressure
  • Maximum oil pressure allowed at the clutch
  • Maximum upshifting time for 2 gears
  • Maximum upshifting time for 3 gears
  • Maximum upshifting time for 4 gears
  • Maximum upshifting time for 5 gears
  • Oil pressure during adaptations
  • Oil pressure correction based on TOT
  • Gear based pressure verification
  • R-US
  • RPM for the engine stall with ESP OFF
  • Shift time with torque reduction
  • Shift time with torque reduction 2
  • Shift timing for gear downshift without load
  • Vehicle speed target for gear shift

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
0GC300014H 1.94.0060GC300014H 2801 BOSCH DQ381

ECU notes

Microprocessor SH72549 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata