AUDI RS3 (8VA) 2.5L L5 20V TFSI 270kW/362HP MED17.1.1

ECU BOSCH MED17.1.1 · 367 CV (27 kW) · 2500 cc · Benzina sovralimentato

ECU DatabaseAUDI › AUDI RS3 (8VA) 2.5L L5 20V TFSI 270kW/362HP MED17.1.1

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 6 firmware versions

Vehicle data

BrandAUDI
ModelRS3 (8VA)
Engine2.5L L5 20V TFSI 270kW/362HP MED17.1.1
Stock power367 CV / 27 kW
Displacement2500 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.1.1
Memory / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Available tuning operations / options:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Boost pressure limit control
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio limiting for compressor depending on IAT sensor
  • Desired pressure ratio
  • Exhaust gas temperature
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • RPM limiter 4
  • RPM Limiter 5
  • RPM limit for EOT sensor
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum boost pressure load
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Max torque profile (overboost active)
  • Optimal engine moment
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation 2
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Driver torque request 2
  • Torque limiter for selected gear
  • Throttle angle management

Firmware identifiers (6)

Hardware No.Software No. (chip)VersionUpdate softwareECU
1.00.0088V0907404 0007 BOSCH MED17.1.1
1.00.0338V0907404 0002 BOSCH MED17.1.1
1.00.0328V0907404 0003 BOSCH MED17.1.1
1.00.0198V0907404 0004 BOSCH MED17.1.1
1.00.0208V0907404 0005 BOSCH MED17.1.1
1.00.0148V0907404 0006 BOSCH MED17.1.1

Vehicle technical notes

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU notes

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata