AUDI R8 (42) 5.2L V10 40V FSI 455kW/610HP MED17.1.1

ECU BOSCH MED17.1.1 · 619 CV (455 kW) · 5200 cc · Benzina sovralimentato

ECU DatabaseAUDI › AUDI R8 (42) 5.2L V10 40V FSI 455kW/610HP MED17.1.1

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) 1 firmware versions

Vehicle data

BrandAUDI
ModelR8 (42)
Engine5.2L V10 40V FSI 455kW/610HP MED17.1.1
Stock power619 CV / 455 kW
Displacement5200 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED17.1.1
Memory / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Available tuning operations / options:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • High pressure fuel pump setpoint
  • High pressure fuel pump setpoint 2
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • Knock detection factor
  • Speed limiter
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Driver torque request Sport mode
  • Torque limiter for selected gear
  • Throttle angle management

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
1.94.0024S0907552AL 0001 BOSCH MED17.1.1

ECU notes

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata