AUDI A6 (C8/4K) 40 2.0L 16V TFSI 140kW/188HP MG1CS001

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

Vehicle data

ECU

Available tuning operations / options:

• Maximum air charge for overboost protection with turbocharger fault
• Maximum air charge for overboost protection with turbocharger fault 2
• Base timing
• Advance at idle speed
• Advance at idle speed 2
• Advance at idle speed 3
• Optimal spark timing/MBT
• Optimal spark timing/MBT 2
• Boost pressure limiter 2
• Desired engine load calculation
• Lambda correction for engine temperature after starting
• Maximum torque limitation at clutch
• Compression ratio for turbocharger protection
• Compression ratio limiting for compressor depending on IAT sensor
• Maximum pressure ratio limit for diagnosis
• Max accepted exhaust gas temperature at exhaust manifold
• Exhaust gas temperature
• Maximum exhaust gas temperature GPF in regeneration mode for component protection
• Exhaust valves lift
• Weighting map cold-start
• Max torque correction factor for ECT sensor
• Filling factor limit
• Factor for reducing maximum filling
• Engine torque reducing factor depending on temperature
• Max CAT temperature threshold for component protection
• HFM/HLM air flow high limit
• High pressure fuel pump setpoint
• High fuel pressure pump limit for ECT sensor
• High fuel pressure pump limit
• Intake valve lift
• L
• Torque limiter
• Lambda enrichment for components protection
• Lambda value for components protection activation
• Lambda correction for exhaust manifold temperature
• RPM limiter - N
• RPM limiter in Park position
• RPM limit for ECT sensor
• Driver torque request limiter
• Knock detection factor
• Speed limiter
• MAF sensor calibration
• Maximum indicated torque
• Throttle air mass flow calculation
• Manifold absolute pressure time delay
• Characteristic manifold absolute pressure time constant of the LRS
• Maximum intake manifold pressure
• Maximum relative engine air charge
• Maximum throttle angle opening for a given RPM
• Max torque profile
• Optimal engine moment
• Power limit torque table
• Turbo pressure variation control factor
• Turbo pressure variation control factor 2
• Turbo pressure variation control factor 3
• Specific air mass charge - correction
• % relative air filling limit depending on IAT
• Driver torque request
• Driver torque request 2
• Setpoint maximum turbocharger speed
• Throttle angle management
• Target Lambda for knock protection
• Torque limiter in recovery mode
• Torque limiter in recovery mode 2
• Torque limiter in recovery mode 3
• Torque limiter in recovery mode 4
• Torque limiter in recovery mode 5

Firmware identifiers (3)

ECU notes

Get the file for this vehicle

Tools to read and write this ECU

Flex Programmatore per rimappatura centraline e cambi automatici ECU + auto gearbox € 1.000 Buy The Genius OBD + Bench € 2.500 Buy

Other AUDI

→ All ECUs AUDI