AUDI A1 (8X) 2.0L 16V TFSI QUATTRO 188kW/252HP MED9.1

ECU BOSCH MED9.1/5 · 256 CV (188 kW) · 2000 cc · Benzina sovralimentato

ECU DatabaseAUDI › AUDI A1 (8X) 2.0L 16V TFSI QUATTRO 188kW/252HP MED9.1

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 1 firmware versions

Vehicle data

BrandAUDI
ModelA1 (8X)
Engine2.0L 16V TFSI QUATTRO 188kW/252HP MED9.1
Stock power256 CV / 188 kW
Displacement2000 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelMED9.1/5
Memory / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Available tuning operations / options:

  • Base timing
  • Optimal spark timing/MBT
  • Boost pressure limiter 4
  • Boost pressure limiter 5
  • Boost pressure limit control
  • Height correction for boost pressure
  • Desired engine load calculation
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • HFM/HLM threshold for diagnosis
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum boost pressure load
  • Throttle air mass flow calculation
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware identifiers (1)

Hardware No.Software No. (chip)VersionUpdate softwareECU
0261S028821037524303 1.58.0088X0907115A 0010 BOSCH MED9.1/5

Vehicle technical notes

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU notes

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This Setting File can be used for serial system : Genius or NewGenius. To work on this ECU you can use NewTrasdata

Add-on modules available

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop