Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.
✓ Tuning via file (flash)
✓ Add-on module available 4 firmware versions
Vehicle data
| Brand | ALFA ROMEO |
| Model | MiTo |
| Engine | 1.4L 16V TB Multiair 99kW/133HP IAW8GF |
| Stock power | 135 CV / 99 kW |
| Displacement | 1400 cc |
| Fuel | Benzina sovralimentato |
| Vehicle type | Auto |
ECU
| Manufacturer | MARELLI |
| Model | 8GF |
| Memory / EPROM | MICRO BGA MOTOROLA FRESCALE con FLASH interna 12288 Kbit - 0x180000 |
Available tuning operations / options:
- Optimal spark timing/MBT
- Advance at part load
- Advance correction
- Base lambda - cold
- Base Lambda - hot
- Boost pressure limiter
- Electronic throttle control
- Compressor pressure ratio limit for pumping and speed
- Average power effective limitation
- Average torque effective limitation
- Advance limiter
- Basic value setpoint Lambda sensor
- Maximum Upstream pressure in event of Normal boost modality
- Maximum Upstream pressure in event of normal boost modality, Sport mode activated
- Maximum Upstream pressure in event of overboost modality
- Maximum Upstream pressure in event of overboost modality, Sport modality activated
- Max torque profile
- Torque management in Normal mode
- Torque management Sport mode
- Power Control in Normal mode
- Power Control in Sport mode
- Power limit torque table
- Resistant torque table
- Torque limit table for ECT sensor
- Take-off torque law in Normal mode
- Take-off torque law in Normal mode with power control
- Take-off torque law in Sport mode
- Take-off torque law in Sport mode with power control
- Wastegate duty-cycle
Firmware identifiers (4)
| Hardware No. | Software No. (chip) | Version | Update software | ECU |
|---|
| MM8GMFHW502 | 1N00CA41 |
1.91.020 | — |
MARELLI 8GF |
| MM8GMFHW502 | 1M10CA38 |
1.91.015 | — |
MARELLI 8GF |
| MM8GMFHW502 | 1M10DA38 |
1.91.024 | — |
MARELLI 8GF |
| MM8GMFHW502 | 1M10CA39 |
1.91.062 | — |
MARELLI 8GF |
Vehicle technical notes
ECU located on or behind the engine block. It may be necessary to remove the engine cover. Difficulty: easy.
OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.
ECU notes
Microprocessor FMPC5553 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual.
Get the file for this vehicle
Tools to read and write this ECU
