ALFA ROMEO 147 1.6L 16V TS 88kW/118HP ME7.3.1

ECU BOSCH ME7.3.1 · 120 CV (88 kW) · 1600 cc · Benzina aspirato

ECU DatabaseALFA ROMEO › ALFA ROMEO 147 1.6L 16V TS 88kW/118HP ME7.3.1

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 13 firmware versions

Vehicle data

BrandALFA ROMEO
Model147
Engine1.6L 16V TS 88kW/118HP ME7.3.1
Stock power120 CV / 88 kW
Displacement1600 cc
FuelBenzina aspirato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelME7.3.1
Memory / EPROMHYBRID ECU - 4.096Kbit 0x80000

Available tuning operations / options:

  • Advance at part load
  • Lambda correction
  • Load / throttle position reference
  • Injection at part load
  • Injection at full throttle
  • Advance limiter
  • Torque limiter
  • Speed limiter
  • Specific air mass charge 2
  • Load/throttle position reference - AT
  • Air mass flow (diagnostic)
  • Air mass flow

Firmware identifiers (13)

Hardware No.Software No. (chip)VersionUpdate softwareECU
02612067141277356527 1.38.009 BOSCH ME7.3.1
02612067141277356445 1.38.010 BOSCH ME7.3.1
02612067141277356572 1.38.01310A0Xw00 BOSCH ME7.3.1
02612067151277356528 1.38.015 BOSCH ME7.3.1
02612067151277356511 1.38.01810A0Xw00 BOSCH ME7.3.1
02612067151277356446 1.38.016 BOSCH ME7.3.1
02612073391277356566 1.38.004 BOSCH ME7.3.1
02612073401277356520 1.38.006 BOSCH ME7.3.1
02612077271037372523 1.38.01010F0Xw00 BOSCH ME7.3.1
02612077271037351957 1.38.006 BOSCH ME7.3.1
02612077281037367407 1.38.00510C0Xw00 BOSCH ME7.3.1
02612083271037367855 1.38.004 BOSCH ME7.3.1
02612083281277367856 1.38.007 BOSCH ME7.3.1

Vehicle technical notes

OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.

ECU notes

HYBRID ECU! To modify this ECU you need our serial protocol FLASH_0018. Please read the manual handbook to connect the specific cable. WARNING!! ECU ME7 - IX/CL = injection at full load, decrease the values to enrich the injection Note for the SELESPEED version: before disconnecting the ECU make sure that the gearbox is in idle position to avoid car blockage. In that case use the Examiner. If after a correct modification a fault code appears, simply turn on the engine and the fault will be reset automatically after some starts. This Setting File can be used for serial system : Genius or NewGenius.

Add-on modules available

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop