ABARTH GRANDE PUNTO 1.4L 16V TJET SS 132kW/178HP ME7.9.10

ECU BOSCH ME7.9.10 · 180 CV (132 kW) · 1400 cc · Benzina sovralimentato

ECU DatabaseABARTH › ABARTH GRANDE PUNTO 1.4L 16V TJET SS 132kW/178HP ME7.9.10

Find the firmware identifiers (hardware, software and update numbers), available tuning options and how to get the original or remapped file.

✓ Tuning via file (flash) ✓ Add-on module available 3 firmware versions

Vehicle data

BrandABARTH
ModelGRANDE PUNTO
Engine1.4L 16V TJET SS 132kW/178HP ME7.9.10
Stock power180 CV / 132 kW
Displacement1400 cc
FuelBenzina sovralimentato
Vehicle typeAuto

ECU

ManufacturerBOSCH
ModelME7.9.10
Memory / EPROMMICRO ST - 6656 Kbit

Available tuning operations / options:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Spark advance correction for ECT sensor
  • Boost pressure limiter 3
  • Boost pressure limiter 4
  • Boost pressure limiter 5
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Desired pressure ratio
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for EOT sensor
  • Lambda driver wish
  • Knock detection factor
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Max torque profile
  • Optimal engine moment
  • Boost pressure threshold cycles for the overboost recognition
  • Power limit torque table
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Turbocharger volumetric efficiency
  • Wastegate duty-cycle

Firmware identifiers (3)

Hardware No.Software No. (chip)VersionUpdate softwareECU
02612016651037397663 1.91.008 BOSCH ME7.9.10
02612016851037398569 1.91.030 BOSCH ME7.9.10
0261S046621037400604 1.91.040 BOSCH ME7.9.10

Vehicle technical notes

OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.

ECU notes

Microprocessor ST10F275 This Setting File can be used for serial system : Genius or NewGenius. To work on this ECU you can use NewTrasdata