MERCEDES TRUCK BUS 1722 4.8L 4L 160kW/215HP TEMIC

Steuergerät TEMIC TEMIC PLD · 218 CV (16 kW) · 4800 cc · Diesel sovralimentato

Steuergeräte-DatenbankMERCEDES TRUCK › MERCEDES TRUCK BUS 1722 4.8L 4L 160kW/215HP TEMIC

Hier finden Sie die Firmware-Kennungen (Hardware-, Software- und Update-Nummern), verfügbare Tuning-Optionen und wie Sie die Original- oder optimierte Datei erhalten.

✓ Tuning per Datei (Flash) 5 Firmware-Versionen

Fahrzeugdaten

MarkeMERCEDES TRUCK
ModellBUS
Motor1722 4.8L 4L 160kW/215HP TEMIC
Serienleistung218 CV / 16 kW
Hubraum4800 cc
KraftstoffDiesel sovralimentato
FahrzeugtypTir

Steuergerät

HerstellerTEMIC
ModellTEMIC PLD
Speicher / EPROMMICRO INFINEON XC2287 - 6144Kbit - C0000

Verfügbare Tuning-Optionen:

  • Max. Schwellenwert Luftmassenstrom durch den Kompressor
  • Ladedruckbegrenzer
  • Motor Überhitzungsschutz Kennfeld
  • Motor Überhitzungsschutz Kennfeld 2
  • Motor Überhitzungsschutz Kennfeld 3
  • Basis Moment beim Anlassen des Motors
  • Motorleerlaufdrehzahl für ECT-Sensor
  • Einspritzwinkel
  • Einspritzwinkel 2
  • Einspritzwinkelkorrektur
  • PLD Förderwinkel
  • Rauchbegrenzer
  • Angegebener Maximaldrehmoment
  • Maximale Drehmoment Wert

Firmware-Kennungen (5)

Hardware-Nr.Software-Nr. (Chip)VersionUpdate-SoftwareSteuergerät
23E 1.54.008 TEMIC TEMIC PLD
06A 1.54.015 TEMIC TEMIC PLD
22B 1.54.011 TEMIC TEMIC PLD
56E 1.54.016 TEMIC TEMIC PLD
60A 1.54.012 TEMIC TEMIC PLD

Steuergerät-Hinweise

Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. This setting file is enabled for the GENIUS serial tuning; it is required the specific TEMIC connection cable.Please read the specific handbook in order to open the ECU and to solder the wire inside it. On this epron can be set a KEY.
Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. This setting file is enabled for the GENIUS serial tuning; it is required the specific TEMIC connection cable.Please read the specific handbook in order to open the ECU and to solder the wire inside it.
This Setting File can be used for serial system NewGenius.