MERCEDES TRUCK ACTROS 1857 16L V8 419kW/565HP TEMIC

Steuergerät TEMIC TEMIC PLD · 570 CV (419 kW) · 16000 cc · Diesel sovralimentato

Steuergeräte-DatenbankMERCEDES TRUCK › MERCEDES TRUCK ACTROS 1857 16L V8 419kW/565HP TEMIC

Hier finden Sie die Firmware-Kennungen (Hardware-, Software- und Update-Nummern), verfügbare Tuning-Optionen und wie Sie die Original- oder optimierte Datei erhalten.

✓ Tuning per Datei (Flash) 10 Firmware-Versionen

Fahrzeugdaten

MarkeMERCEDES TRUCK
ModellACTROS
Motor1857 16L V8 419kW/565HP TEMIC
Serienleistung570 CV / 419 kW
Hubraum16000 cc
KraftstoffDiesel sovralimentato
FahrzeugtypTir

Steuergerät

HerstellerTEMIC
ModellTEMIC PLD
Speicher / EPROM29F200 PSOP44 2Mbit - Flash 128K x 16 (256K x 8)

Verfügbare Tuning-Optionen:

  • Max. Schwellenwert Luftmassenstrom durch den Kompressor
  • Ladedruckbegrenzer
  • Motor Überhitzungsschutz Kennfeld
  • Motor Überhitzungsschutz Kennfeld 2
  • Basis Moment beim Anlassen des Motors
  • Motorleerlaufdrehzahl für ECT-Sensor
  • Einspritzwinkel
  • Einspritzwinkel 2
  • Einspritzwinkelkorrektur
  • PLD Förderwinkel
  • Rauchbegrenzer
  • Angegebener Maximaldrehmoment
  • Maximale Drehmoment Wert

Firmware-Kennungen (10)

Hardware-Nr.Software-Nr. (Chip)VersionUpdate-SoftwareSteuergerät
W49 1.54.125 TEMIC TEMIC PLD
06A 1.54.014 TEMIC TEMIC PLD
G51 1.54.123 TEMIC TEMIC PLD
B50 1.54.126 TEMIC TEMIC PLD
53H 1.54.013 TEMIC TEMIC PLD
J51 1.54.017 TEMIC TEMIC PLD
G51 1.54.016 TEMIC TEMIC PLD
E51 1.54.130 TEMIC TEMIC PLD
W49 1.54.117 TEMIC TEMIC PLD
B50 1.54.124 TEMIC TEMIC PLD

Steuergerät-Hinweise

Original EPROM PSOP 44 pins 29F200BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. This setting file is enabled for the GENIUS serial tuning; it is required the specific TEMIC connection cable.Please read the specific handbook in order to open the ECU and to solder the wire inside it.
Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. This setting file is enabled for the GENIUS serial tuning; it is required the specific TEMIC connection cable.Please read the specific handbook in order to open the ECU and to solder the wire inside it.