VOLVO TRUCK FL MK I 220 6.6L 162kW/217HP LUCAS

Calculateur LUCAS PLCC 28HC256 · 220 CV (162 kW) · 6600 cc · Diesel sovralimentato

Base de données calculateursVOLVO TRUCK › VOLVO TRUCK FL MK I 220 6.6L 162kW/217HP LUCAS

Retrouvez les identifiants du firmware (numéros hardware, software et mise à jour), les options de tuning disponibles et comment obtenir le fichier d'origine ou reprogrammé.

✓ Tuning par fichier (flash) 13 versions firmware

Données véhicule

MarqueVOLVO TRUCK
ModèleFL MK I
Moteur220 6.6L 162kW/217HP LUCAS
Puissance d'origine220 CV / 162 kW
Cylindrée6600 cc
CarburantDiesel sovralimentato
Type de véhiculeTir

Calculateur

FabricantLUCAS
ModèlePLCC 28HC256
Mémoire / EPROM28HC256 PLCC32 256Kbit - EEprom 32K x 8

Opérations / options de tuning disponibles:

  • Injection au rallenti
  • Injection charge partielle
  • Injection à pleine charge
  • Limiteur de couple
  • Limiteur fumèes au rallentì
  • Limiteur de fumées charge partielle
  • Limiteur de fumeus à pleine charge

Identifiants firmware (13)

N° HardwareN° Software (chip)VersionLogiciel de mise à jourCalculateur
03161965XXXX1948 1.55.106 LUCAS PLCC 28HC256
03161965XXXX1480 1.55.005 LUCAS PLCC 28HC256
08192397XXXX1945 1.55.002 LUCAS PLCC 28HC256
08192397XXXX3674 1.55.115 LUCAS PLCC 28HC256
08192397XXXX3671 1.55.003 LUCAS PLCC 28HC256
08192397XXXX1948 1.55.005 LUCAS PLCC 28HC256
20412508XXXX1945 1.55.002 LUCAS PLCC 28HC256
20412508XXXX1948 1.55.004 LUCAS PLCC 28HC256
20412508XXXX3671 1.55.005 LUCAS PLCC 28HC256
20412508XXXX3P01 1.55.003 LUCAS PLCC 28HC256
20412508XXXX3674 1.55.105 LUCAS PLCC 28HC256
20577133XXXX3075 1.55.108 LUCAS PLCC 28HC256
20577133XXXX8863 1.55.003 LUCAS PLCC 28HC256

Notes calculateur

Original EPROM 28HC256 PLCC 32 pins To read this EPROM with the EMP20 programmer you need PD28 adapters. Attention !! The EMP21 instead needs the PD32 adapters. On this epron can be set a KEY. WARNING !! With the eprom programmer EMP21 at first select device, then choose "DEVICE OPTIONS" and then "DISABLE SDP AFTER PROGRAM" (confirm with "OK"). With EMP20 once the eprom has been programmed, select "B" for disable data protection and confirm with "Y". This Setting File can be used for serial system NewGenius.