VOLKSWAGEN POLO 3 (6N) 1.4L 8V 55kW/74HP ME7.5.10

Calculateur BOSCH ME7.5.10 · 75 CV (55 kW) · 1400 cc · Benzina aspirato

Base de données calculateursVOLKSWAGEN › VOLKSWAGEN POLO 3 (6N) 1.4L 8V 55kW/74HP ME7.5.10

Retrouvez les identifiants du firmware (numéros hardware, software et mise à jour), les options de tuning disponibles et comment obtenir le fichier d'origine ou reprogrammé.

✓ Tuning par fichier (flash) 8 versions firmware

Données véhicule

MarqueVOLKSWAGEN
ModèlePOLO 3 (6N)
Moteur1.4L 8V 55kW/74HP ME7.5.10
Puissance d'origine75 CV / 55 kW
Cylindrée1400 cc
CarburantBenzina aspirato
Type de véhiculeAuto

Calculateur

FabricantBOSCH
ModèleME7.5.10
Mémoire / EPROM29F400 PSOP44 4Mbit - Flash 256K x 16

Opérations / options de tuning disponibles:

  • Avance à charge partielle
  • Référence charge pedal / position du papillon
  • Injection à pleine charge
  • Limiteur de avance
  • Limiteur de couple
  • Référence charge pedal / position du papillon - AT
  • Débit de masse d'air

Identifiants firmware (8)

N° HardwareN° Software (chip)VersionLogiciel de mise à jourCalculateur
02612060021037352362 1.21.015030906032H 3042 BOSCH ME7.5.10
02612067511037352870 1.21.009030906032AP 3245 BOSCH ME7.5.10
02612067661037352861 1.21.005030906032BC 3174 BOSCH ME7.5.10
02612067671037352843 1.21.006030906032BD 3176 BOSCH ME7.5.10
02612071771037360150 1.21.017030906032CF 3621 BOSCH ME7.5.10
02612071781037360148 1.21.015030906032CG 3622 BOSCH ME7.5.10
02612075931037362259 1.21.009030906032DT 3936 BOSCH ME7.5.10
02612085371037370161 1.21.005030906032EL 2902 BOSCH ME7.5.10

Notes calculateur

Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This Setting File can be used for serial system NewGenius. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator.