TOYOTA WISH (AE20) 2.0L 16V 116kW/157HP DENSO

Calculateur DENSO 275922-3410 · 158 CV (116 kW) · 2000 cc · Benzina aspirato

Base de données calculateursTOYOTA › TOYOTA WISH (AE20) 2.0L 16V 116kW/157HP DENSO

Retrouvez les identifiants du firmware (numéros hardware, software et mise à jour), les options de tuning disponibles et comment obtenir le fichier d'origine ou reprogrammé.

✓ Tuning par fichier (flash) 2 versions firmware

Données véhicule

MarqueTOYOTA
ModèleWISH (AE20)
Moteur2.0L 16V 116kW/157HP DENSO
Puissance d'origine158 CV / 116 kW
Cylindrée2000 cc
CarburantBenzina aspirato
Type de véhiculeAuto

Calculateur

FabricantDENSO
Modèle275922-3410
Mémoire / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Opérations / options de tuning disponibles:

  • Avance principale
  • Correction avance à l'allumage pour le capteur ECT
  • Demande d’avance - indice d’octane élevé
  • Demande d’avance - indice d’octane faible
  • Correction d’avance – déphasage position 1
  • Contrôle papillon electronique
  • Contrôle papillon electronique 2
  • Contrôle papillon electronique 3
  • Correction Lambda f(IAT)
  • Correction Lambda f(IAT) 2
  • Correction Lambda f(ECT)
  • Correction Lambda f(ECT) 2
  • Correction Lambda f(ECT) 3
  • Correction Lambda f(ECT) 4
  • Limiteur de avance pour la protection des composants 1
  • Valeur basic de sonda Lambda
  • Enrichissement Lambda - open loop
  • Limiteur de tours
  • Lambda demandée
  • Limiteur de vitesse
  • Délimitation % maximum de remplissage d'air en fonction de la IAT
  • Demande de couple
  • Capteur de température d'échappement

Identifiants firmware (2)

N° HardwareN° Software (chip)VersionLogiciel de mise à jourCalculateur
89663-0M022- 1.67.00330M02200 DENSO 275922-3410
89663-0M020- 1.67.02230M02000 DENSO 275922-3410

Notes techniques véhicule

OBD située sous la colonne de direction, au dessus des pédales. Visible ou masquée par un couvercle plastique.

Notes calculateur

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata