FORD GALAXY 1.9L 8V TDI 82kW/110HP Motronic

Calculateur BOSCH MOTRONIC EDC TDI · 111 CV (82 kW) · 1900 cc · Diesel sovralimentato

Base de données calculateursFORD › FORD GALAXY 1.9L 8V TDI 82kW/110HP Motronic

Retrouvez les identifiants du firmware (numéros hardware, software et mise à jour), les options de tuning disponibles et comment obtenir le fichier d'origine ou reprogrammé.

✓ Tuning par fichier (flash) 4 versions firmware

Données véhicule

MarqueFORD
ModèleGALAXY
Moteur1.9L 8V TDI 82kW/110HP Motronic
Puissance d'origine111 CV / 82 kW
Cylindrée1900 cc
CarburantDiesel sovralimentato
Type de véhiculeAuto

Calculateur

FabricantBOSCH
ModèleMOTRONIC EDC TDI
Mémoire / EPROM27C020 DIL32/PLCC32 2Mbit - Eprom 256K x 8

Opérations / options de tuning disponibles:

  • Injection pour le capteur de pression turbo 1
  • Limiteur de pression turbo
  • Pression turbo
  • Controle van EGR
  • Phase injection
  • Limiteur de couple
  • Limiteur de fumées
  • Pre-injection base
  • Débit de masse d'air

Identifiants firmware (4)

N° HardwareN° Software (chip)VersionLogiciel de mise à jourCalculateur
02810017361037356005/006 1.01.014 BOSCH MOTRONIC EDC TDI
02810017371037352601/602 1.01.004 BOSCH MOTRONIC EDC TDI
02810017371037357728/9 1.01.010 BOSCH MOTRONIC EDC TDI
02810019681037357607/8 1.01.009 BOSCH MOTRONIC EDC TDI

Notes techniques véhicule

OBD avec un couvercle située dans le tunel central dans le compartiment entre le levier de vitesse et la commande de climatisation.

Notes calculateur

2 original EPROM 27C010 or 29F010 PLCC 32 pins. To read this EPROM with the EMP20/21 programmer you need PD32 adapters. 16 Bit setting file. This works with a file obtained with the merge of EPROM HHH + LLL. On this epron can be set a KEY.
2 original EPROM 27C010 PLCC 32 pins. To read this EPROM with the EMP20/21 programmer you need PD32 adapters. On this epron can be set a KEY. 16 Bit setting file. This works with a file obtained with the merge of EPROM HHH + LLL.
2 original EPROM 27C010 PLCC 32 pins. To read this EPROM with the EMP20/21 programmer you need PD32 adapters. 16 Bit setting file. This works with a file obtained with the merge of EPROM HHH + LLL. On this epron can be set a KEY.