CITROEN JUMPY 2.0L 8V HDI 69kW/93HP EDC15C2

Calculateur BOSCH EDC15C2 · 94 CV (69 kW) · 2000 cc · Diesel sovralimentato

Base de données calculateursCITROEN › CITROEN JUMPY 2.0L 8V HDI 69kW/93HP EDC15C2

Retrouvez les identifiants du firmware (numéros hardware, software et mise à jour), les options de tuning disponibles et comment obtenir le fichier d'origine ou reprogrammé.

✓ Tuning par fichier (flash) 9 versions firmware

Données véhicule

MarqueCITROEN
ModèleJUMPY
Moteur2.0L 8V HDI 69kW/93HP EDC15C2
Puissance d'origine94 CV / 69 kW
Cylindrée2000 cc
CarburantDiesel sovralimentato
Type de véhiculeLCV

Calculateur

FabricantBOSCH
ModèleEDC15C2
Mémoire / EPROM29F400 PSOP44 4Mbit - Flash 256K x 16

Opérations / options de tuning disponibles:

  • Limiteur de pression turbo
  • Pression turbo
  • Controle van EGR
  • Injection charge partielle
  • Injection à pleine charge
  • Limiteur de couple
  • Limiteur de fumées
  • Débit de masse d'air
  • Temps d'overboost

Identifiants firmware (9)

N° HardwareN° Software (chip)VersionLogiciel de mise à jourCalculateur
02810103591037353045 1.05.017 BOSCH EDC15C2
02810105911037353871 1.05.0091037353871 BOSCH EDC15C2
02810108151037353963 1.05.0081037353963 BOSCH EDC15C2
02810108151037370509 1.05.0061037370509 BOSCH EDC15C2
02810108151037353822 1.05.0051037353963 BOSCH EDC15C2
02810108161037353626 1.05.010 BOSCH EDC15C2
02810113421037376576 1.05.0041037376576 BOSCH EDC15C2
02810113431037364457 1.05.0131037364457 BOSCH EDC15C2
02810114491037371449 1.05.0081037371449 BOSCH EDC15C2

Notes techniques véhicule

OBD située sous la colonne de direction, au dessus des pédales. Visible ou masquée par un couvercle plastique.

Notes calculateur

Original EPROM PSOP 44 pins 29F400BT. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. This Setting File can be used for serial programming system NewGenius.
Original EPROM PSOP 44 pins 29F400BT. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. This Setting File can be used for serial system : Genius or NewGenius.