AUDI A6 (C5/4B) 4.2L V8 32V 331KW/444HP ME7.1.1

Calculateur BOSCH ME7.1.1 · 450 CV (331 kW) · 4200 cc · Benzina aspirato

Base de données calculateursAUDI › AUDI A6 (C5/4B) 4.2L V8 32V 331KW/444HP ME7.1.1

Retrouvez les identifiants du firmware (numéros hardware, software et mise à jour), les options de tuning disponibles et comment obtenir le fichier d'origine ou reprogrammé.

✓ Tuning par fichier (flash) 6 versions firmware

Données véhicule

MarqueAUDI
ModèleA6 (C5/4B)
Moteur4.2L V8 32V 331KW/444HP ME7.1.1
Puissance d'origine450 CV / 331 kW
Cylindrée4200 cc
CarburantBenzina aspirato
Type de véhiculeAuto

Calculateur

FabricantBOSCH
ModèleME7.1.1
Mémoire / EPROM29F800 PSOP44 8Mbit - Flash 512K x 16

Opérations / options de tuning disponibles:

  • Avance à charge partielle
  • Référence charge pedal / position du papillon
  • Injection charge partielle
  • Limiteur de avance
  • Limiteur de couple
  • Enrichissement Lambda pour la protection des composants
  • Limiteur de cliquetis
  • Débit de masse d'air

Identifiants firmware (6)

N° HardwareN° Software (chip)VersionLogiciel de mise à jourCalculateur
02612083631037371177 1.42.0084F0910560 0050 BOSCH ME7.1.1
02612087291037376039 1.00.0184F0910560C 0030 BOSCH ME7.1.1
02612087291037371927 1.42.0084F0910560C 0010 BOSCH ME7.1.1
02612087291037374011 1.42.0174F0910560C 0020 BOSCH ME7.1.1
02612089211037378147 1.42.0074F0910560E 0020 BOSCH ME7.1.1
02612089441037374362 1.42.0074F0910560F 0010 BOSCH ME7.1.1

Notes techniques véhicule

OBD située à gauche du côté conducteur, accessible sans rien retirer, à la gauche du pédalier.

Notes calculateur

Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This Setting File can be used for serial system NewGenius. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator.